Installation Guide
H-100 / Win2000 / Access-T / Zapp driver 


Connect the serial end to Hyundai Data Cable. Connect the USB - RS232 (serial) converter to USB port


Handset setup
Select RM Speed for H-100 Handset: 

press menu; 

press 7; 

press 3 
select 230400 using up/down arrows
USB to Serial adapter installation 
USB to RS232 converter (adapter) requires a driver installation. This driver should have been provided by the converter's vendor. Connect the USB end of the converter to USB port of your computer.
You shall see the message: "found new hardware / USB Device"

Followed by New Hardware Wizard window

Next 

Select Search for a suitable driver for my device
Next

Specify a location 

Next 

Click Browse to the location where your USB driver is located (this driver should be provided with the USB - SERIAL converter)


Next

Finish
Modem installation
note: the H-100 is equipped with a built-in modem, which means you don't need to buy a modem if you want to connect to Internet using a dial-up connection. For this reason, the PC/laptop needs to be set-up in a similar scenario as an external modem set-up. This paragraph will guide you through the steps you need to follow in order to get this modem installed.
Make sure you have the proper privilege on your computer running Windows2000 to start the following operation.
After you closed all your running applications (recommended), click the Windows Start button 

And go to Control Panel.
 

Double click "Phone and Modem Options" icon within the Control Panel 

Press "Modems" tab; 

Press Add button; 
 
Click the check box named "Don't detect my modem; I will select it from a list"; 

Next (you will see "Add/Remove Hardware Wizard" window) 

Have Disk


Browse to the location where your Zapp CDMA Hyundai H-100 modem driver is located (we recommend to keep the zapp driver in a special folder like c:\drivers\zapp_drivers)

Select Zapp CDMA Handset (With USB 230k serial conv) model

Next

Select the proper communication port to which your CDMA device is connected. 
(USB driver should have previously installed a virtual COM; i.e. COM5). In order to use USB port you should select this new installed COM.
Next 
Windows will install your modem.

Finally you shall see a confirmation message: "Your modem has been set up successfully."

Finish
As result, the standard modem we have just installed shows up in the modems list on Phone and Modem Options tab.

On Phone and Modem Options tab, go to Modems tab, and click on Properties button
Zapp CDMA Handset (with USB serial conv) Window will open up as a result.

On General tab, Maximum Port Speed field, choose 230400.
Click OK (two times).
You have successfully installed the Zapp Modem.
Establish a dial-up connection
Click Start.
Move Mouse on Settings and then click on Network and Dial-up Connections

As result, Network and Dial-up Connections window will show up.

Double-Click on Make New Connection
As result, Network Connection Wizard window will show-up.

Next.

Select Dial-up to private network
Next

Select the modem device: Modem - Zapp CDMA Handset (With USB 230k serial conv)
Next

The phone number to dial is: #777
Next

Select an option (i.e. For all users)
Next

Type a name for the connection (i.e. Zapp )
Finish


Type any user name / password
Click Dial.
As result the dialing window will show up.

Wait until the connection is established. This may take a few seconds.

After the connection is established, the window will disappear and a new icon will be displayed in the right side of your Windows 2000 task bar.
You have now successfully connected to Internet.