H-100 / 2000 / Serial / Zapp driver

# Cables
Having the H-100 turned on, get the Hyundai serial cable (Hyundai data cable) and connect it to the mobile telephone 

The RS-232 plug will be connected to the serial port of your computer 

Select RM Speed for H-100 Hanset: 
press menu; 
press 7; 
press 3 ; 
select 115200 using up/down arrows

Note: the serial cable, due to manufacturing purposes, limits the data transfer speed at 115.2 Kbps. 
For reaching higher data transfer speed an USB to serial adapter should be used

# Modem installation
note: the H-100 is equipped with a built-in modem, which means you don't need to buy a modem if you want to connect to Internet using a dial-up connection. For this reason, the PC/laptop needs to be set-up in a similar scenario as an external modem set-up. This paragraph will guide you through the steps you need to follow in order to get this modem installed. Make sure you have the proper privilege on your computer running Windows2000 to start the following operation. After you closed all your running applications (recommended), click the Windows Start button and go to Control Panel.

double click "Phone and Modem Options" icon within the Control Panel 
press "Modems" tab; 
press Add button; 
click the check box named "Don't detect my modem; I will select it from a list"; 
click Next (you will see "Add/Remove Hardware Wizard" window) 
click on "Have Disk" button

Browse to the location where your Zapp CDMA Hyundai H-100 modem driver is located (we recommend to keep the zapp driver in a special folder like c:\drivers\zapp_drivers)

Select Zapp CDMA Handset (Standard 115k serial port) model
click next
Select the proper communication port (COM1 or COM2) to which your CDMA device is connected.
Click Next; you shall see a confirmation message: "Your modem has been set up successfully."
Click Finish
As result, the standard modem we have just installed shows up in the modems list on Phone and Modem Options tab.
On Phone and Modem Options tab, go to Modems tab, and click on Properties button
(Zapp CDMA Handset (Standard 115k serial port) Window will open up as a result.)
On General tab, Maximum Port Speed field, choose 115200.
Click OK (two times)
You have successfully installed a new modem on your PC/laptop connected to the H-100 by using a serial cable on COM1. The next step in the process of getting a connection to Internet is to establish a dial-up connection. Go to next paragraph.

# Establish a dial-up connection
Click Start.
Move Mouse on Settings and then click on Network and Dial-up Connections
As result, Network and Dial-up Connections window will show up.
Double-Click on Make New Connection
As result, Network Connection Wizard window will show-up.
Click Next.
Select Dial-up to private network
Click Next
Select the modem device: Modem - Zapp CDMA Handset (Standard 115k serial port) (COM1)
Click Next
The phone number to dial is: #777
Click Next
Select an option (i.e. For all users)
Click Next
Type a name for the connection (i.e. Zapp )
Click Finish
The User name field will be automatically filled in (for the time being the username is not important).
The Password field may be left blank .2
Click Dial.
As result the dialing window will show up.
Wait until the connection is established. This may take a few seconds.
After the connection is established, the window will disappear and a new icon will be displayed in the right side of your Windows 2000 task bar.
You have now successfully connected to Internet world. You need to open your Internet browser (Internet Explorer, Netscape, etc.), go to Open Page field and type any WWW address you want to reach.