S-200 / Windows2000 / USB Direct Cable (by Prolific) / Zapp driver

# Handset setup
Press Menu > Press 6 key > Press 2 key
Select Computer Speed for S-200 Handset -  230400 using up/down arrows

# USB Direct Cable (by Prolific) Installation
USB Direct Cable (by Prolific) requires a driver installation. 
When you plug for the first time the USB cable into PC, you shall see this message: found new Hardware / USB Device)
Followed by New Hardware Wizard window
Next 
Select Search for a suitable driver for my device
Next
Click  Specify a location 
Click Next 
Click Browse to the location where your USB  Cable driver is located. 
Select Win2K folder.
Next
Finish

# Modem installation
note: the handset is equipped with a built-in modem, which means you don't need to buy a modem if you want to connect to Internet using a dial-up connection. For this reason, the PC/laptop needs to be set-up in a similar scenario as an external modem set-up. This paragraph will guide you through the steps you need to follow in order to get this modem installed.
Make sure you have the proper privilege on your computer running Windows2000 to start the following operation.
After you closed all your running applications (recommended), click the Windows Start button 
and go to Control Panel.
Double click "Phone and Modem Options" icon within the Control Panel 
Press "Modems" tab.
Add.
Click the check box named "Don't detect my modem; I will select it from a list.
Click Next (you will see "Add/Remove Hardware Wizard" window) 
Have Disk
Browse to the location where your Zapp Modem driver is located.
Select Zapp CDMA Handset (With USB 230k serial conv) model
Next
Select the proper communication port to which your CDMA device is connected. 
(USB driver should have previously installed a virtual COM; i.e. COM5). In order to use USB port you should select this new installed COM.
Next.
Windows will install your modem.
Finally you shall see a confirmation message: "Your modem has been set up successfully."
Click Finish
As result, the standard modem we have just installed shows up in the modems list on Phone and Modem Options tab.
On Phone and Modem Options tab, go to Modems tab, and click on Properties button
Zapp CDMA Handset (with USB serial conv) Window will open up as a result.
On General tab, Maximum Port Speed field, choose 230400.
Click OK (two times)
You have successfully installed a new modem on your PC. 
The next step in the process of getting a connection to Internet is to establish a dial-up connection. Go to next paragraph.

# Establish a dial-up connection
Click Start.
Move Mouse on Settings and then click on Network and Dial-up Connections
As result, Network and Dial-up Connections window will show up.
Double-Click on Make New Connection
As result, Network Connection Wizard window will show-up.
Next.
Select Dial-up to private network
Next
Select the modem device: Modem - Zapp CDMA Handset (With USB 230k serial conv)
Next
The phone number to dial is: #777
Note:  Uncheck  “Use dialing rules”  
Next
Select an option (i.e. For all users)
Next
Type a name for the connection (i.e. Zapp )
Finish
Enter a any user name
Enter any password
Dial.
As result the dialing window will show up.
Wait until the connection is established. This may take a few seconds.
You have now successfully connected to Internet.